Anillo líquido - Serie A de una sola fase
Modelo: A5, A10, A15, A20, A75, A100, A130, A200, A300
Aplicaciones: Vacuum Packaging, Extruders, Solvent Distillation/Vapor Recovery, Sterilization, Degasifiers, Evaporators, Freeze Drying, Vapor Coating, Gas Compression
Compartir
Features
- Simplistic in design, rugged in construction
- Built to run in the most severe of industrial conditions
- Unique design allows pump to operate flooded, without damage
- Flat power curve over entire vacuum range prevents motor overload
- No contact between operating components in the casing
- Pull down to 29” Hg - 25 Torr (33 mbar a)
- Increased water handling capability prevents heat build-up, extends life of single mechanical seal
- Reduced stress on motor shaft and bearings
- Available in stainless steel, bronze, or cast iron (A200 & A300 models available in cast iron)
- Compact, close-coupled design eliminates need for interstage manifold or motor alignment
A Series pumps are not as susceptible to cavitation compared to flat plate design because the flow path through the pump is an axial flow. This allows the velocity through the pump to be unchanged and carries the air out effortlessly.
It is not unusual for these pumps to run 24/7 operation for years without maintenance.
A Series pumps are vibration-free and environmentally friendly with no oil used for lubrication, and no oil discharged to atmosphere.
Complete, self-contained systems including liquid recovery and recirculation are available.
Características
Features
- Simplistic in design, rugged in construction
- Built to run in the most severe of industrial conditions
- Unique design allows pump to operate flooded, without damage
- Flat power curve over entire vacuum range prevents motor overload
- No contact between operating components in the casing
- Pull down to 29” Hg - 25 Torr (33 mbar a)
- Increased water handling capability prevents heat build-up, extends life of single mechanical seal
- Reduced stress on motor shaft and bearings
- Available in stainless steel, bronze, or cast iron (A200 & A300 models available in cast iron)
- Compact, close-coupled design eliminates need for interstage manifold or motor alignment
A Series pumps are not as susceptible to cavitation compared to flat plate design because the flow path through the pump is an axial flow. This allows the velocity through the pump to be unchanged and carries the air out effortlessly.
It is not unusual for these pumps to run 24/7 operation for years without maintenance.
A Series pumps are vibration-free and environmentally friendly with no oil used for lubrication, and no oil discharged to atmosphere.
Complete, self-contained systems including liquid recovery and recirculation are available.